Perel Tools HGG400PRO Notice D'emploi page 3

1. Introduction
Thank you for choosing Perel! Please read the manual thoroughly before bringing this device into service.
If the device was damaged in transit, don't install or use it and contact your dealer.
2. Safety Instructions
Keep out of reach of children and unauthorized users.
Keep this device away from rain and moisture.
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty
and the dealer will not accept responsibility for any ensuing defects or problems.
• Keep the device away from splashing and dripping liquids.
• Do not use the device when damage to housing is noticed. Do not attempt to service the device
yourself but contact an authorised dealer.
• Note that damage caused by user modifications to the device is not covered by the warranty.
3. General Guidelines
• Protect this device from shocks and abuse. Avoid brute force when operating the device.
• Protected the device against extreme heat, dust and moisture.
• Familiarise yourself with the functions of the device before actually using it.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. Using the device in an unauthorised way will void the
warranty.
4. Features
• rigid extension
• greasing head
• refilling by suction
• injection or cartouche
• 400cc
5. Overview
Refer to the drawing on page 2 of this manual.
6. Loading the gun
Cartridge loading
• Hold the gun body [3], plunger handle [4] pointing downwards.
• Unscrew the head assembly [5] by turning it counter clockwise with respect to the gun body [3].
• Pull the plunger handle [4] out of the gun body [3] until the groove in the rod becomes visible.
Secure the handle by pushing the groove in the slot of the gun body.
• Insert a grease cartridge (not incl.), open end first, into the gun body [3]. Remove the seal or pull
tab from the cartridge.
• Screw the head assembly [5] back in place and release the plunger handle [4] from the slot.
• Pull back and release the plunger handle [4] a couple of times to ensure good contact between the
rubber ring inside the body and the cartridge.
• Push the plunger handle [4] into the gun body as far as possible.
00 (17/09/2008)
HGG400PRO
User manual
3