Publicité
Les langues disponibles
Les langues disponibles
c)
Only mild detergents designed for cleaning food contact surfaces may be used to clean the unit.
d)
After each cleaning, all parts should be thoroughly dried before the device is reused.
e)
Store the unit in a dry and cool place protected from moisture and direct sunlight.
f)
Do not spray the unit with a stream of water or immerse it in water.
g)
Make sure that no water enters through the ventilation openings in the casing.
h)
Clean the ventilation openings with a brush and compressed air.
i)
Perform regular inspections of the unit checking technical fitness and any damages.
j)
Use a soft, damp cloth for cleaning.
k)
Do not use sharp and/or metal objects (e.g. wire brush or metal spatula) as they may damage the surface
of the material from which the appliance is made.
l)
Do not clean the unit with acidic substances, medical agents, thinners, fuel, oils, or other chemicals. It
may cause damage to the device.
3.5.
Error codes
Error code
The main board cannot connect to the control
EC/E16
panel.
E0
Electrical circuit failure.
E1
Protection against empty vessels.
E2
Low voltage protection.
E3
High voltage protection.
E4
Circuit of the temperature sensor is open.
E4
Short circuit on the temperature sensor.
E7
Open circuit of the IGBT sensor.
E7
Short circuit on the IGBT sensor.
E8
Overheating of the temperature sensor.
E9
Overheating of the IGBT sensor.
DISPOSAL OF USED UNITS.
At the end of its useful life, this product should not be disposed of with normal household waste but should
be taken to a collection point for the recycling of electrical and electronic equipment. This is indicated by
the symbol on the product, operating instructions, or packaging. The materials used in this appliance are
recyclable according to their marking. By reusing, recycling, or applying other forms of use of waste
machines, you make a significant contribution to the protection of our environment.
Your local administration will provide you with information about the appropriate disposal point for used
appliances.
Error
Analysis
Check the connection of the wires between
the main board and the display control board.
Check the coil.
Is the pan placed on the induction hob? Is the
vessel compatible with the hob?
Check the voltage value.
Check the voltage value.
Check if the temperature sensor is damaged or
disconnected.
Check if the temperature sensor is damaged in
its insulation or if its metal wire is exposed.
Check if the socket is damaged.
Check if the IGBT sensor is damaged or
disconnected.
Check if the IGBT sensor has insulation
damage or if its metal wire is exposed.
Check if the socket is damaged.
Check if the fans under the coil are damaged
or if there is poor heat dissipation.
Check if the fans on the main board are
damaged or if the air intake is blocked,
resulting in poor heat dissipation.
Publicité
