Back to Basics SLUSHIE EXPRESS SITSELP Mode D'emploi page 6

4. Holding the cup bottom, press cup down and turn clockwise to engage Motor
Base.
5. Run motor until ice is finely crushed, mixture appears "slushie" and the top of
the slushie mixture forms a funnel shape. Mix time is about 15 – 20 seconds.
6. If ice gets jammed in the blades at the beginning of processing and prevents the
blades from spinning, turn cup counter-clockwise to disengage motor and stop
machine. Gently shake the Cup to dislodge ice and repeat steps 4 and 5.
Note: Jammed ice is most often caused by using large ice cubes frozen in ice
trays. Ice from a refrigerator/freezer ice maker, smaller cube trays, larger trays
filled only half full or purchased bagged ice works best.
7. When slushie is done, turn Cup counter-clockwise to disengage motor and stop
machine.
8. Remove Slushie Cup from Motor Base and turn right side up.
9. Turn Blade Base counter-clockwise and remove from Slushie Cup.
10. Attach Slushie Cup Lid by placing over the top of the Slushie Cup and turning
clockwise.
11. Use the Spoon/Straw to eat and drink your frozen slushie treat. Enjoy!
FLAVOR STRENGTH - To increase the flavor, add more syrup and less water. To
decrease the flavor, add less syrup and more water. Note: Be sure to keep the total
liquid ingredients no higher than the "Liquid" marking and ice no higher than the "Ice"
marking on the Slushie Cup.
C
Before using the first time and after each use, be sure to thoroughly wash the blade
base, slushie cup, lid and spoon/straw in warm, soapy water. Rinse and dry
thoroughly. Do not wash any parts in dishwasher.
DO NOT SUBMERGE THE MOTOR BASE IN WATER OR ANY OTHER LIQUID.
WIPE CLEAN AFTER EACH USE WITH A DAMP CLOTH.
Note: The Slushie Express includes a small, clear Gasket inside the rim of the
Blade Base and Slushie Cup Lid. This Gasket provides an effective seal between
the Slushie Cup and Blade Base/Lid. The Gasket does NOT need to be removed. If
the clear Gasket becomes dislodged from the Blade Base or Lid, replace by setting
the Gasket flat onto the circular slot inside the perimeter of the Blade Base (blade
side up) or the Lid. Holding the Blade Base (blade side up) or Lid with both hands,
use your thumbs to lightly push the Gasket down into the circular slot of the base
perimeter until it is firmly in place. Screw the Slushie Cup onto the Blade Base or Lid
to ensure the Gasket is seated properly.
All manuals and user guides at all-guides.com
Y S
LEANING OUR
6
E
LUSHIE XPRESS
™