Operation; Cleaning - Zipper Maschinen ZI-COM200-10 Manuel D'utilisation

12.2

Operation

Switch on:
Pull out the On-Off-switch
Switch off:
Press back in the On-Off-switch
Setting output pressure:
The output pressure can be set with the
pressure regulator
Output pressure:
The output pressure is shown on the
manometer output pressure
Air tank pressure:
The air pressure is shown on the manometer air pressure
Output 1 and 2:
To connect a device place the union joint into the coupling. The sleeve will go to starting position
automatically. To disconnect pull the sleeve backwards and remove the hose.
13 MAINTENANCE
The machine does not require intense maintenance. However, to ensure a long lifespan, we strongly
recommend following the upkeep and maintenance plan.
Repairs must be carried out by specialists! Use original ZIPPER parts only!
Only a properly maintained equipment may be a satisfactory tool. Care and maintenance deficiencies
can cause unpredictable accidents and injuries.
Repairs should be performed only by authorized service centers.
Improper operation may damage the equipment or endanger your safety.
13.1

Cleaning

Keep the safety devices free of dirt and dust as far as possible. Wipe the machine with a clean cloth or
blow it with compressed air at low pressure.
Do not use cleaning agents or solvents; these could attack the plastic parts of the
machine!
Put on all coatless flats a thin coat of oil.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-COM150-10 ; ZI-COM200-10
 Switch off and disconnect from the power supply!
 Let cool down the air compressor!
 Depressurize the air tank
A T T E N T I O N
Bevor maintenance:
N O T I C E
N O T I C E
MAINTENANCE
21