Whirlpool CAM2752 Instructions D'installation page 6

1/2"
(13 mm)
Base
Nut
10.
Use legs and nuts from parts
package. Screw nut down to within
1/2 inch (13 mm) of
base.
11.
Insert legs into correct
holes at each front corner
of washer until nuts touch washer.
Do Not tighten nuts until Step 14.
12.
Tilt washer backward and
remove corner posts. Gently lower
washer to floor.
Move washer to its permanent
location. Remove cardboard or
hardboard from under washer.
13.
Tilt washer forward raising
back legs 1 inch (25 mm) off of floor.
To adjust rear self-leveling legs, gently
lower washer to floor. Check levelness
of the washer by placing a
carpenter's level on top of the
washer, first side to side; then front to
back.
14.
If washer is not level, adjust
the front legs up or down. Make final
check with level.
When washer is level, use wrench
to turn nuts on front legs up tightly
against washer base. If nuts are not
tight against washer base, the washer
may vibrate.
PAGE 6
All manuals and user guides at all-guides.com
15.
Remove the service door of
the meter case. Lift the service door
up at the back and remove. Install
money accepting device (refer to
manufacturers instructions for proper
installation). For washers using coin
slides, use adapter kit (provided with
washer). Replace meter case service
door.
Security
Cone
16.
Install added security device.
• Ensure power is not supplied to the
washer.
• Open and remove the service
door.
• Lay the security cone small side
down over the oblong hole in the
bottom rear of the meter case
assembly.
• Pass the security bolt through this
cone and thread it by hand into
the cage nut below the oblong
opening.
• Tighten the security bolt by hand a
few turns before using a wrench to
tighten until snug.
NOTE: Installing the security bolt
provides added security, but will add
to the service time when the top needs
to be removed for servicing the
washer.
17.
REQUIREMENTS. BE SURE YOU HAVE
CORRECT ELECTRICAL SUPPLY AND
RECOMMENDED GROUNDING
METHOD.
18.
installed. See parts list, Page 3. If there
is an extra part, go back through
steps to see which step was skipped.
19.
Security
Bolt
check for leaks. Tighten couplings if
there is leaking. Do Not overtighten;
this could cause damage to faucets.
Cage
Nut
20.
your tools. Check that the shipping
strap was removed from the back of
the washer and used to secure the
drain hose.
If entire strap is not removed, washer
may vibrate and be noisy.
21.
grounded outlet.
CHECK ELECTRICAL
Check that all parts are now
Turn on water faucets and
Check that you have all of
Plug power supply cord into