Trevi RC 830D Mode D'emploi page 4

RC 830 D
CONTROLS
1. button, radio on/off
2. CLOCK button, time settings
3. SNOOZE/DIMMER button, momentary alarm stop/display
brightness adjustment
4. TU-/MIN button, radio frequency scan / minute setting
5. TU+/HOUR button, radio frequency scan / hour setting
6. VOL+/AL2 button, volume control / alarm2 setting
7. PROG button, saved radio station selection / radio station
autosave function.
8. MEM/SLEEP button, 12/24-hour display / manual radio
station save function / sleep function
9. VOL-/AL1 button, volume control / alarm1 setting
10. FM antenna
11. 5V DC power inlet
12. CR2025 buffer battery
4 4
All manuals and user guides at all-guides.com
FM ALARM CLOCK
INSTALLATION
Insert the plug of the power supply provided into a
230V~50Hz mains outlet and the jack into the unit's 5V
DC power inlet (11).
Your RC 830D clock radio is provided with a buffer battery,
used to keep the clock working and to retain the set time in
memory even in case of a temporary power cut.
Should the battery go flat, remove it from the battery com-
partment (12) and replace it observing the correct polarity.
CLOCK AND 12/24-HOUR DISPLAY
SETTINGS
Once power is supplied to the unit, the display will blink,
prompting you to set the time.
If it is not blinking, hold down the CLOCK button (2).
Press the TU+/HOUR button (5) to set the hours.
Press the TU-/MIN button (4) to set the minutes.
Press the CLOCK button (2) to confirm your setting.
Hold down the MEM/SLEEP button (8) to display the time
in the 12 or 24-hour display mode.
ALARM CLOCK SETTINGS
Your clock radio has 2 independent alarms.
While the time is displayed, hold down the VOL-/AL1 button
(9) to activate the alarm1 function ('AL1' will appear on
the display).
Press the TU+/HOUR button (5) to set the hours.
Press the TU-/MIN button (4) to set the minutes.
Press the VOL-/AL1 button (9) to switch to the alarm type.
Press the TU+/HOUR button (5) or the TU-/MIN button (4)
to set the alarm to buzzer (bU22) or radio tuner (rAdI) mode.
Press the VOL-/AL1 button (9) to confirm your alarm setting.
Note: if you set the alarm to radio tuner mode, press the
TU+/HOUR button (5) or the TU-/MIN button (4) to set
the volume. Press the VOL-/AL1 button (9) to confirm.
The alarm is now activated (AL1 will appear on the display)
and it will sound at the time shown.
When the alarm sounds, press the SNOOZE/DIMMER button
(3) to temporarily stop the alarm and activate the SNOOZE
function (AL1 will blink on the display). The alarm will
resume after 9 minutes.
To stop the alarm completely, press the VOL-/AL1 button
(9) while it is sounding.
To deactivate the alarm, press the VOL-/AL1 button (9) while
the time is displayed, until AL1 disappears from the display.
Note: To activate the alarm2 function, follow the same
procedure as above, but use the VOL+/AL2 button (6).
ENGLISH