Publicité
Prepare the heater for use by carrying out the instruction in
the following order:
1. Unpacking
Remove the heater from the cardboard box.
Remove all protections of chock out of polystyrene
Remove the sticky tape from the protection grid and open it
as described below:
1. Push the grid forward.
2. Push the grid upwards.
3. Pull the bottom of the grid facing you.
4. Pull the grid downwards.
Reverse the process to install the grid.
Remove the packing material from the conbustion cylinder.
Open the lid of the fuel tank compartment and remove the
material which protected it during transport.
2. Fitting the combustion cylinder
Place the combustion cylinder on the circular wick guide.
Turn the combustion cylinder lever to the left and then half
way to the right until the combustion cylinder is correctly
positioned in the circular wick guide.
3. Fitting the batteries ( LR14 or Type C)
Unscrew the batteries case protection , take off the top of
the battery case and then place 4 batteries in the battery
case at the rear of the heater. Make sure that you respect
the polarities +/- as indicated in the drawing. Screw the bat-
teries case protection.
•
•
•
- Risk of electric shock. When igniting, the electrodes liberate high voltage. One
must keep away from the electrodes.
- Right after a consumer removes batteries and presses down the
ignition lever, high voltage may be discharged.
- Before cleaning up or repairing the heater, a consumer must
remove batteries and discharge electricity by pressing down the
ignition lever.
INSTRUCTIONS FOR USE
IMPORTANT: DANGER:
Never remove the batterie while the heater is operating
Make sure of the quality of your batteries
Never light your heater with matches or a lighter or other fire.
60
Move from side to side
Move from side to side
Publicité
