BorMann Elite BFN6110 034766 Mode D'emploi page 5

EN
OPERATION
MAINTENANCE
• Always disconnect the appliance before cleaning or doing any maintenance work.
• Never use a wet sponge or cloth to clean the appliance.
• In order to avoid any damage to the product, it is recommended to use protective equipment when handling fragile surfaces and products that protect
the device from damage.
TROUBLESHOOTING
Problem
The fan will not start.
Fan makes excessive noise.
Motor makes excessive noise.
Fan vibrates/ wobbles unnaturally.
5
5. Connect the fan blade and fork and then fasten on the motor.
6. The lamp is connected with the motor, and the fast terminal is used to connect the lamp.
7. Install a E27 40w bulb and glass casing at last.
All settings and functions may be controlled via the remote contol. The operating instructions
of the remote control are illustrated on pages 2 and 3.
In order to change the rotational direction, turn the switch situated on the fan to the left or right.
Possible Cause
• Fuse or circuit breaker blown.
• Loose power line connections to the fan.
• Top canopy touching ceiling.
• Loose fan blades screws.
• Ceiling fan not secured against ceiling.
• Fan blades are not horizontal to ceiling.
• Blade screws are loose.
WWW.NIKOLAOUTOOLS.GR
Solution
• Check main and branch circuit fuses or circuit breakers.
• Check line wire connections to fan.
• Loose fan blades screws minimum 3mm clearance.
• Re-tighten all screws on fan blades but never over-tighten.
• Re-tighten all screws in the hanging bracket or plate.
• Allow at least for 8 hours setting-in period.
• Measure from ceiling to tips of blades, then rotate fan so all
blades are checked for equal height from ceiling. Adjustments
can be made by applying slight pressure to the blade
connection.
• Make sure all screws are securely fastened.