Klarstein Oceana Mode D'emploi page 39

All manuals and user guides at all-guides.com
Important instructions
• The salt container should only be refilled when the salt warning light on the control
panel is lit. Depending on how well the salt dissolves, the salt warning light will still
light up when the salt container is filled. If there is no salt warning light on the control
panel (on some models), you can use the cycles the dishwasher has undergone to
determine when to refill with salt.
• If you spill some salt, start the quick program (Rapid) to remove the excess salt.
Step 1: Call up rinsing salt settings
Close the door within 60 seconds of powering on, press and hold the Start/Pause
button for 5 seconds.
Step 2: Adjust the amount of rinsing salt according to water hardness
Press the Start/Pause button to select the correct setting according to your water
hardness: H1 > H2 > H3 > H4 > H5 > H6. For the correct water softener setting, refer to
the table below in the „Water hardness and rinsing salt quantity" section.
Step 3: Leave rinsing salt settings
If you do not make another setting for 5 seconds, the unit will automatically exit the
settings and enter standby mode.
Water hardness and rinsing salt quantity
Water hardness
1)
2)
°dH
mmol/l
0-5 0 - 0.94
6-1 1 1.0 - 2.0
12-17 2.1 - 3.0
18-22 3.1 - 4.0
23-34 4.1 - 6.0
35-55
6.1 - 9.8
(1) German water hardness.
(2) Millimoles, international water hardness.
(3) Default when first started
Note: Ask your local water supplier about the degree of hardness of your tap water.
Softener
Display
setting
1
H1
2 H2
3 H3
3)
4 H4
5 H5
6
H6
Salt consumption
(g/cycle)
0
4
8
13
20
40
EN
39