Sony AIR-SA20PK Guide Rapide

English
To stabilize S-AIR reception
Read the following when S-AIR reception is poor or unstable.
To use S-AIR products (S-AIR main unit and sub unit)
Before using S-AIR products, have the following ready.
• Confirm the wireless transceivers are inserted
correctly.
Insert the wireless transceivers firmly to the depth
into the slots of the S-AIR main unit and sub unit
respectively.
• Confirm that the S-AIR IDs of the S-AIR main unit
and sub unit are the same.
The default setting of the S-AIR IDs of the S-AIR
main unit and sub unit is "A."
Depending on the S-AIR product, you can set the
S-AIR ID by the switch or the setup menu.
For details, refer to the operating instructions of
each S-AIR product.
About environments where S-AIR products (S-AIR main unit and sub
unit) are used
S-AIR products use a radio frequency of 2.4 GHz. Certain electronic equipment or other factors may
cause lost connection or instability in S-AIR reception.
• Electronic equipment influence
The following may cause interference or cross talk.
– Cellular phones, cordless phones
– Wireless LAN, personal computers
– Game machines using radio signals
– Microwave ovens
• Other factors
The following may cause poor reception.
– Materials or structures, such as walls and floors
– The location where an S-AIR product is placed
When using S-AIR products, place them as far as possible from the above electronic equipment, or
place where S-AIR reception is stable.
©2008 Sony Corporation Printed in China
4-119-532-21(1)
When S-AIR reception is poor
Check the following.
Keep cords that are connected to the S-AIR product (power supply cord, power cord, antennas or
other cords) away from the wireless transceiver and slot.
Keep as much space as possible around S-AIR products.
Avoid placing S-AIR products on top of, or directly below, other electronic equipment.
Insert firmly
Avoid placing S-AIR products in a closed rack, metal rack, or under a table.
Same S-AIR ID
Adjust the location (height, orientation, and place in the room) of S-AIR products until reception is
the most stable.
Place so that the wireless transceivers of the S-AIR main unit and sub unit are closer.
Place so that S-AIR products are separated from other wireless devices.
Place so that S-AIR products are separated from metal doors or tables.
If you cannot improve S-AIR reception, change the "RF CHANGE" setting. For details, refer to the
operating instructions of each S-AIR product.