Far Tools TECH POWER TCR520 Mode D'emploi page 20

Angle of disc
03
Placing in water
04
How to make a straight cut
05
How to make an angled cut
06
Settings of the machine
FIG. F
Adjusting the Laser
01
Replacing consumables
FIG. G
Disc (see machine assembly)
01
Cleaning and maintenance
Cleaning the filter
01
Wash the machine with water after use. Dry with a soft cloth. Always use a good quality disc
that is not damaged. Ensure that the water level is always high enough.
Use of laser
07
Use of the guides
08
EN