Publicité
Les langues disponibles
Les langues disponibles
Viewing the Remote Control
Installing Batteries in the Remote Control
1.
2.
3.
Selects a target device to be
controlled by the Samsung remote
control (TV, DVD, STB, CABLE, VCR)
(Refer to page 37~41)
Television Standby button
Number buttons for direct
channel access
One/Two-digit channel selection
Selects the HDMI mode directly
Selects the TV mode directly
VCR/DVD Functions
Rewind, Stop, Play/Pause,
Fast/Forward
Volume increase
Volume decrease
Temporary sound switch-off
Menu display and
change confirmation
Sound mode selection
It displays "Channel Manager"
on the screen
Picture effect selection
PIP FUNCTIONS
PIP: Picture-In-Picture On / Off
SOURCE: Input source selection
SWAP: Interchange the main and
P
P
Sound effect selection
SRS TSXT selection
SET: Adjusts 5 separate devices - TV,
DVD, STB, CABLE, or VCR.
RESET: When your remote does not
work, change the batteries and press
the "RESET" button for 2-3 seconds
before use.
Available source selection
The performance of the remote control may be affected by bright light.
This is a special remote control for the visually impaired,
and has Braille points on the Power, Channel and Volume buttons.
Lift the cover at the back of the remote control upward as shown in the figure.
Install two AAA size batteries.
Make sure to match the "+" and "–" ends of the batteries with the diagram inside the compartment.
Replace the cover.
Remove the batteries and store them in a cool, dry place if you won't be using the remote control for a
long time. The remote control can be used up to about 23 feet from the TV.
(Assuming typical TV usage, the batteries last for about one year.)
If the remote control doesn't work, check the following:
1. Is the TV power on?
2. Are the plus and minus ends of the batteries reversed?
3. Are the batteries drained?
4. Is there a power outage, or is the power cord unplugged?
5. Is there a special fluorescent light or neon sign nearby?
sub picture
: Next channel
: Previous channel
English-6
When pressing this button, a number of
buttons on the remote control (e.g.
Selects a target device, volume, channel and
MUTE buttons) light up for a few seconds and
then turn off to save power. This function is
to conveniently use the remote control at
night or when dark.
Previous channel
Selects the PC mode directly
This function enables you to load saved
photo (JPEG) and audio files (MP3)
and to view or play them on the TV.
P
: Next channel
P
: Previous channel
Exit the OSD
Control the cursor in the menu
Use to see information on the
current broadcast
Picture freeze
Picture size selection
Automatic Power-off
Teletext Functions
Exit from the teletext display
Teletext index
PIP: Teletext hold
SOURCE: Teletext size selection
SWAP: Teletext store
Teletext mode selection (LIST/FLOF)
Teletext sub page
P
: Teletext next page
P
: Teletext previous page
Teletext cancel
Teletext reveal
Alternately select Teletext, Double, or Mix.
Fastext topic selection
Publicité
