1618750_6095_CrptExt_PRINTfinal.qxp_Layout 1 9/3/19 1:34 PM Page 8
Problem solving
ENGLISH
Make sure machine is turned off and electrical power cord is unplugged.
Problem
Motor is not running.
Loss of vacuum suction.
Brush not functioning
properly.
Spray tips not functioning
properly.
SERVICE INFORMATION
If your Sanitaire product
should require service
You will find the nearest Sanitaire Authorized
Service Center in your area online at
sanitairecommercial.com under service locator
or contact Sanitaire Customer Service.
If you need information about repairs or
replacement parts, or if you have questions
about your warranty, contact Sanitaire
Customer Service.
8
Cause
1) Power not reaching main switch.
2) Defective power cord.
3) Faulty switches or wiring.
4) Blown fuse or tripped circuit breaker
5) Problem with brushes, field windings, or
armatures (vacuum or brush motor).
1) Vacuum head blocked.
2) Hoses blocked.
3) Recovery tank not sealed properly.
1) Belt broken.
2) Brush jammed.
3) Clutch bearing seized.
1) Tips blocked.
2) Solution filter blocked.
3) Pump head, valves or diaphragm
blocked or damaged.
4) Solenoid valve inoperative.
Website:
www.sanitairecommercial.com
Call:
Sanitaire Customer Service
1-800-800-8975
Monday – Friday
9 a.m. – 8:30 p.m. EST
Solution
1) Check power supply. Check fuses/circuit
breaker. Contact service center.
2) Replace with 14-gauge cord.
3) Contact manufacturer or service center.
4) Reset circuit breaker according to operating
instructions or replace fuse if qualified.
5) Contact manufacturer or service center.
1) Visually inspect and clear blockage.
2) Visually inspect and clear blockage.
3) Check tank for damage or adjust lid for
proper fit.
1) Replace belt.
2) Visually inspect and clear blockage.
3) Contact manufacturer or service center.
1) Visually inspect and clean according to
operating instructions.
2) Visually inspect and clean according to
operating instructions.
3) Contact manufacturer or service center.
4) Contact manufacturer or service center.