General Instructions; Extension Cords - Sanitaire 6095 Série Guide De L'utilisateur

Extracteur à tapis autonome
Table des Matières

Publicité

1618750_6095_CrptExt_PRINTfinal.qxp_Layout 1 9/3/19 1:34 PM Page 4

General instructions

ENGLISH
Pre-operation instructions
NOTE: (color fastness) Before using carpet cleaning chemicals,
test on an inconspicuous part of the carpet for color fastness.
Place the solution on a small piece of clean white material or
tissue, then rub the carpet vigorously. Excessive amounts of dye
showing on the material would indicate that the colors are not
fast, and should not be wet cleaned.
1) Fill the solution tank with 9 gallons of warm water.
WARNING: Do NOT overfill.
2) Measure carpet cleaning solution per manufacturers
recommended ratio into the clean water / solution tank. DO
NOT use the waste / recovery tank to fill the solution tank as
debris could damage the pump or block the jet.
WARNING: DO NOT exceed 150°F (65°C).
3) Add defoamer solution per manufacturer's instructions
as needed.
Operation of self-contained carpet cleaner
1) Plug main power cable into outlet.
WARNING: This machine must be properly grounded.
2) Press the vacuum switch to the ON position. Then press the
pump switch ON and the brush switch to the ON position.
3) Lower carpet brush. Push brush-lowering pedal forward to
lower brush. Push down and back to raise brush.
4) Press and hold the solution switch to apply the cleaning
solution. Pull the machine backwards at the same time to clean
the carpet. Stop the solution spray about 12" (30cm) before the
end so all of the solution is vacuumed up. Slightly overlap the
next cleaning pass to prevent streaking. A two (2) wet pass
maximum is recommended to avoid over wetting. After a few
passes, check the waste / recovery tank to see that no foam is
present. Add extra defoamer if necessary.
5) Make sure to empty the waste / recovery (top) tank when it is
approximately 3/4 full. Do not refill the solution tank without
emptying all the contents of the waste / recovery tank first.
4

Extension cords

When using an extension cord with your unit, refer to the following
table to determine the required A.W.G. wire size. Before using the
cleaner, make sure the power cord and extension cord are in
good working condition. Make repairs or replacements before
using the vacuum cleaner.
NOTE: Only use extension cords that are rated for outdoor use.
Length of extension cord
25 feet
50 feet
110V-120V
7.5 meter
15.25 meter
Amps
0-6
18
7-10
18
11-12
16
13-16
14
How to identify parts
Cómo identificar las piezas
Comment identifier les pièces
Switch panel
Waste / recovery tank
Tablero de interruptores
Tanque de recuperación / desechos
Panneau de commande
Réservoir de récupération
Brush and spray
Cepillo y aspersor
Brosse et vaporisateur
100 feet
150 feet
30.5 meter
45.7 meter
A.W.G. wire size
16
16
14
16
16
14
16
14
12
12
Not recommended
Clear water / solution tank
Tanque para agua limpia / soluciones líquidas
Réservoir d'eau propre et de solution
Vacuum shoe
Patín de aspiración
Sabot d'aspiration

Publicité

Table des Matières
loading

Table des Matières