Télécharger Imprimer la page

Hilti SR 6-A22 Mode D'emploi Original page 15

Masquer les pouces Voir aussi pour SR 6-A22:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18
5. Allow the locking lever to return to its original position.
6. Grip and pull the saw blade to check that it is locked in position.
5.6
Installing the dust removal adapter (accessory)
1. Pull the contact shoe out.
2. Set the dust removal adapter on the contact shoe mount.
3. Insert the lightly greased contact shoe fully into the guide.
6
Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1
Guiding the saw
1. Hold the saw by the grips provided for the purpose.
2. Guide the saw to the workpiece.
3. Guide the saw forward and back.
▶ If you press the saw against the workpiece there is a risk of the saw blade breaking and causing
injuries.
6.2
Sawing
6
WARNING
Risk of injury by defective scaffold hook! A falling tool could injure you or others.
▶ Before starting work, check that the scaffold hook is secure and undamaged.
1. Disengage the transport lock and press the control switch.
▶ The graphics section illustrates various ways of guiding the saw effectively.
2. Release the control switch when you finish the cut.
3. Engage the transport lock.
6.3
Removing the saw blade
CAUTION
Risk of injury! The accessory tool may be hot and/or have sharp edges.
▶ Wear protective gloves when changing the accessory tool.
▶ Never lay down a hot accessory tool on a flammable surface.
1. Engage the transport lock or remove the battery from the power tool.
2. Push the locking lever up as far as it will go and hold it in this position.
3. Pull the blade forward out of the blade holder.
4. Allow the locking lever to return to its original position.
7
Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care and maintenance of the tool
Carefully remove stubborn dirt from the tool.
Clean the air vents carefully with a dry brush.
Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
Clean and lubricate the chuck from the outside at regular intervals. Use the Hilti spray 314648 for this
purpose.
Care of the Li­ion batteries
Keep the battery free from oil and grease.
*2186516*
5
7
2186516
4
English
9

Publicité

loading