Publicité
Les langues disponibles
Les langues disponibles
CLEANING THE LENS
Blow off loose particles using clean compressed air.
Carefully wipe the surface with a moist cotton swab.
The swab may be moistened with water.
CLEANING THE HOUSING
Use soap and water on a damp sponge or soft cloth.
To avoid damage to the Thermometer, do not soak the unit into water.
To avoid damaging the Thermometer, do NOT submerge it in water.
Caution!
Symptom
OL (on display)
-OL (on display)
Blank Display
Laser does not
work
Beeper beeps
continuously
The Thermometer conforms to the following standards:
- EN61326: 2006
- EN60825-1: 1994+A2: 2001+A1: 2001+A1: 2002 Laser Safety Standard
Certification testing was conducted using a frequency range of 80 to 100MHz with instrument
in three orientations.
INFRARED AND T-C THERMOCOUPLE
INFRARED
Measurement Range (COD. 51262)
Spectral Range
TROUBLESHOOTING
Table 4. Troubleshooting
Problem
Target temperature is over range
Target temperature is under range
Low Battery
Possible dead battery
1. Low or dead battery
2. Ambient temperature above 40ºC
(104ºF)
1. Has the High/Low feature been
set? And
2. Measurement value has over the
limit
CE CERTIFICATION
SPECIFICATIONS
-50ºC to 1550ºC (-58ºF to 2822ºF)
8 to 14 um
Action
Select target with specifications
Select target with specifications
Replace Battery
Check and / or replace battery
1. Replace battery
2. Use in area with lower ambient
temperature.
3. Reset the setting or
4. Cancel the limit setting
31
Publicité
