Publicité
Les langues disponibles
Les langues disponibles
Button /
Description
Connector
Press YELLOW button to toggle between MAX, MIN, DIF, AVG, HAL, LAL,
YELLOW
DATA nad T-C options.
Button
Press YELLOW to turn the Thermometer on again and displays the last
measurement result.
Press to enter set up mode.
SET
Details refer to the below User Setup topics.
Press
backlight, level two display backlight and turning off the display backlight.
Press
DATA
Data transfer button to be used with
When the Thermometer enters the setup up mode, press
option, details refer to the below User Setup topics.
When the Thermometer enters the user setup mode, press
option, details refer to the below User Setup topics.
Insert the K type thermocouple into this jack to carry out contact temperature
TC-K jack
measurement.
POWER jack
Insert the power adaptor into this jack.
After connecting the USB cable, the Thermometer automatically selects USB
power supply and two levels white colour Backlit Display will be on.
USB port
With the software installed, it could carry out data transferring and
management.
Infrared thermometers measure the surface temperature of an opaque object. The
Thermometer's optics sense infrared energy, which is collected and focused onto a detector.
The Thermometer's electronics then translate the information into a displayed temperature
reading which appears on the display. The laser is used for aiming purposes only.
BUTTONS AND CONNECTOR
Figure 4. Buttons and Connector
Table 2. Buttons and Connector
to step through turning the display backlight on, level one display
icon will be on and off also.
to turn the laser on and off. After laser is on,
HOW THE THERMOMETER WORKS
will be shown.
. Details refer to User Setup topics.
to select an
to select an
21
Publicité
