Publicité
Les langues disponibles
Les langues disponibles
Josef Kihlberg JK24-690
7
Before all maintenance tasks on the
stapler always first disconnect it from
the air supply.
7.1 CLEANING THE STAPLER
This stapler does not require special servicing. It only
needs regular cleaning with a non-aggressive (non-
corrosive) cleaner agent. Do not remove any parts for
cleaning purposes!
Check the proper functioning of all safety
devices daily. Make especially sure that:
–
the trigger works smoothly, the door stays in place
and the magazine lid does not open itself.
–
all screws and nuts are securely tightened.
–
the stapler is regularly lubricated (refer to chapter
5.2).
7.2 REMOVING JAMMED STAPLES
To remove a staple which has become jammed:
– Pry the door open with a screw driver (Fig. 5/1)
from the left hand side.
– Remove any staple remnants inside the tool nozzle
and close the door again until it clicks shut.
8
PREVENTIVE AND CORRECTIVE MAINTENANCE
Fig. 5
1
05.20
Publicité
