Velleman DVM892N Mode D'emploi page 15

DVM892N
Make sure the meter is closed tight and put the protective edge back in
place before using the meter.
17. Troubleshooting
If the device beeps continuously while measuring continuity, this means that
the F500 mA/1000 V internal fuse is defective. Replace this fuse.
Keep in mind that a low battery level could lead to incorrect measurements.
Replace the battery on a regular basis.
(tip: the reduced luminosity of the backlight/LCD display indicates a low
battery level)
Use this device with original accessories only. Velleman Group nv
cannot be held responsible in the event of damage or injury
resulting from (incorrect) use of this device. For more info
concerning this product and the latest version of this manual, please
visit our website www.velleman.eu. The information in this manual
is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman Group nv. All
worldwide rights reserved. No part of this manual may be copied,
reproduced, translated or reduced to any electronic medium or otherwise
without the prior written consent of the copyright holder.
V. 03 – 19/08/2021
15 ©Velleman Group nv