SEVERIN 7146000 Mode D'emploi page 24

i
nsTallinG anD charGinG ThE appliancE
3 Installing and charging the appliance
For additional installation tips, see  Quick Start Guide  Installation.
Installing the wall mount
1
Charging the rechargeable battery with wall mount
The rechargeable battery has to be charged using the wall mount before first use. It is best to charge the
rechargeable battery
before each use, especially if the appliance has not been used for a while. This increases the useful life
of the rechargeable battery and ensures the longest possible cleaning cycles.
1. Make sure that the appliance is switched off (On/Off switch in the "0" position).
2. Connect the mains adapter included in the delivery to a socket.
3. Insert the appliance into the wall mount.
The LED on the handle flashes red. The charging process starts.
–
The LEDs light up green continuously if the rechargeable battery is fully charged. The charging
–
process takes around 5 hours when the rechargeable battery is empty.
TIP: The appliance can remain in the charging station so that it is ready for use at all times. For further
information, see also  illustrated Quick Start Guide.
24
1. Select an attachment location within drilling range of a socket.
2. Hold the wall mount to the wall, aligned in a vertical position.
3. Mark the drilled holes with a pencil.
4. Drill the holes (approximately 6 mm Ø).
5. Insert the dowels included in the delivery into the holes.
6. Fasten the wall mount using the screws included in the delivery.