Publicité
Les langues disponibles
Les langues disponibles
1.1)
SAFETY LABELLING AND WARNING SIGNS
DANGER, WARNING AND CAUTION
The words DANGER, WARNING and CAUTION are used to
identify the levels of seriousness of certain hazards. It is
important that you understand their meaning. You will notice
these words in the manual as follows:
DANGER
Immediate hazards which WILL result in death or
serious injury.
WARNING
Hazards or unsafe practices which CAN result in
death or injury.
CAUTION
Hazards or unsafe pratices which CAN result in
personal injury or product or property damage.
READ
CAREFULLY
INSTRUCTIONS WITH THE UNIT.
1.2)
INSPECTION OF MERCHANDISE UPON
ARRIVAL
Carefully unpack and inspect the shipment to see if any
damage has occurred during shipment. Our responsibility
ceases upon delivery to the carrier. If parts are missing or
damage has occurred an immediate claim should be filed
with the carrier. Then, check the contents of each carton
against the packing slip, should there be any parts missing,
file a detailed claim together with a copy of your packing slip.
All shipments are checked by an inspector before they are
accepted by the carrier.
1.3)
LOCATION
The location of the water heater must be level and as close
as possible to the chimney ON A NON-COMBUSTIBLE
FLOOR.
NOTE : If the basement temperature is under 60°F
(16°C) or if the house temperature is under 60°F
(16°C)
there
is
an
condensation inside the chimney.
All manuals and user guides at all-guides.com
INSTALLATION
AND
LEAVE
THESE
increased
possibility
of
PART 1
1.4)
INSTALLATION
The installation of the unit shall be in accordance with the
regulations of the authorities having jurisdiction. For recommended
installation practices, see the latest CSA code & supplements, for
the installation of oil burner equipment.
CSA B139
NFPA 31
ANSI/NFPA 70
CSA C22.1
1.5)
ACCESS FOR MAINTENANCE
Convenient access shall be provided to permit cleaning of
heating surfaces, flue pipe and for burner maintenance.
Minimum clearances from combustible material should be:
IB32-R-A / IBO32-O-A
Sides
Rear
Top
Front
Flue
1.6)
SHIPPING COMPONENTS
The unit is shipped in two separate cartons, the first carton is
for the water heater tank, the second is for the burner, the
aquastat(s), the wiring harness, the safety relief valve and
the start collar.
1.7)
WATER CONNECTIONS
Make the hot and cold water connections to the water heater.
Do not apply heat to hot water outlet and cold water inlet,
they contain a plastic sleeve or dip tube. The pressure relief
valves are installed on the units.
To avoid water damage and/or scalding due to relief valve
operation, a discharge line must be connected to the valve
outlet and run to a drainage area. The discharge line shall be
installed in such a way that it will allow for the complete
drainage of the valve and discharge line.
1.8)
BLOCKED VENT SHUT-OFF (BVSO
For chimney venting
It is imperative that this device be installed by a
qualified agency.
This device is designed to detect the insufficient evacuation
of combustion gases in the event of a vent blockage. In such
a case the thermal switch will shut down the oil burner. The
device will then need to be re-armed MANUALLY.
Installation code for oil burning equipment
Installation of oil burning equipment
National Electrical Code
Canadian Electrical Code
IBO50-O-A
5.08 cm (2")
15.20 cm (6")
5.08 cm (2")
15.20 cm (6")
45.70 cm (18")
45.70 cm (18")
61.00 cm (24")
61.00 cm (24")
22.90 cm (9")
22.90 cm (9")
CAUTION
WARNING
)
3
Publicité
