Bosch HCB50651UC Manuel D'utilisation page 8

Audible signal
Switching on audible signal
Press and hold the "Light" button for 5 seconds.
▯
An audible signal sounds and "Snd" appears on the
▯
display panel for 3 seconds.
Switching off audible signal
Press and hold the "Light" button for 5 seconds.
▯
"Snd" appears on the display panel for 3 seconds.
▯
Cleaning and maintenance
WARNING
9
WARNING
To avoid risk of fire and explosion do not use
flammable liquids or solvents. Always unplug or
disconnect the appliance from the power supply
before servicing.
Do not use steam cleaners to clean the appliance.
Hidden surfaces may have sharp edges. Use caution
when reaching behind or under appliance.
WARNING
9
RISK OF BURNS
The appliance will become hot when in use,
especially in the area surrounding the bulbs. Let
cool before cleaning.
WARNING
9
RISK OF ELECTRIC SHOCK
Penetrating damp can cause electric shock. Only
clean appliance with a damp cloth. Prior to cleaning,
pull the plug or flip the breaker in the fusebox.
Cleaning agents
To prevent various surfaces from becoming damaged
due to incorrect cleaning agents, follow the specifications
given in the table. Do not use
cleaning agents that are harsh or scouring,
▯
cleaning agents with high alcohol content,
▯
hard scouring pads or sponges,
▯
high-pressure cleaners or steam cleaners.
▯
Thoroughly rinse all new sponges before use.
8
Overheating protection
The appliance is equipped with overheating protection. If
high temperatures are measured on the appliance, the
appliance switches automatically to the highest ventilator
setting until the temperature drops again.
If the hood is switched on, the highest ventilator setting
▯
is set. If the temperature drops again, the appliance
switches back to the previously-selected ventilator
setting.
If the hood is switched off, the appliance switches
▯
automatically to the highest ventilator setting. If the
temperature drops again, the appliance switches off
automatically.
While the overheating protection is active, "Auto"
▯
appears on the display panel. The ventilator setting
cannot be reduced in this time.
Observe all instructions and warnings accompanying
cleaning agents.
Area Cleaning agents
Stainless steel Warm soapy water:
Clean with a dish rag and dry with
a soft towel.
Only clean stainless steel with the
grain.
Specific products for stainless
steel care are available from cus-
tomer service or from specialized
retailers. Apply a thin layer of the
care product with a soft cloth.
Varnished sur- Warm soapy water:
faces Clean with a damp dish rag and
dry with a soft towel.
Do not use stainless steel
cleaner.
Aluminum and Glass cleaner:
plastic Clean with a soft cloth.
Glass Glass cleaner:
Clean with a soft cloth. Do not use
a glass scraper.
Controls Warm soapy water:
Clean with a damp dish rag and
dry with a soft towel.
Risk of damage to electronics
due to permeating damp. Never
clean controls with a wet cloth.
Do not use stainless steel
cleaner.