Publicité
Les langues disponibles
Les langues disponibles
Insert a Finishing Wheel
Remove the knurled
head screw (F).
Attention!
For mounting the Rubber air roller remove one of the keys.
Let the machine run for a short period of time and in a safe position. If the
machine does not run easily, stop working immediately.
Switch the machine on and put it carefully on the surface you want to work
on. Hold the tool with both hands and work with circular or linear
movements. Never put on the whole surface of the sanding disc. Always
grind with a small angle between grinding disc and the surface of the work
piece.
Usage of abrasive belts
Mount the expansion wheel on the machine. Put the abrasive belt around
the work piece you want to grind. Connect the ends of the abrasive belt
and put it on the expansion wheel.
Attention!
Never load the abrasive belt so much that it rips.
Working Advice
When sanding, the removal capacity and the surface quality are mainly
determined by the abrasive selection as well as through the preselected
speed. Work with the lowest possible sanding pressure in order to increase
the service life of the abrasive. Excessively increasing the sanding
pressure does not lead to a higher sanding capacity, but to more wear of
the power tool and the abrasive. Work with moderate feed and perform the
sanding parallel and overlapping with respect to the sanding paths.
Use only original EIBENSTOCK sanding accessories.
Only proper abrasives achieve good sanding capacity and give the power
tool longer service life.
Do not clamp power tools in the saw stand. Clamped power tools and
sharp-edged application tools may result in serious injury.
F
Put the wheel in a way on the connection
shaft that it can be recepted by the two
keys of the shaft. Secure the finishing
wheel by means of the knurled head
screw.
20
Publicité
