Télécharger Imprimer la page

T.I.P. TFU 2000 UV 9 Mode D'emploi page 14

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
Make sure that the O-rings are properly seated in the corresponding groove in the housing in the quartz
glass socket. Grease the O-rings with Vaseline if required. Push the quartz glass completely into the housing
of the lamp. Make sure that the nose of the quartz glass tube and the notch of the UVC cover are positioned
correctly. Check that the protective cap of the tube is fitted. Carefully push the lamp holder with the UVC
tube into the quartz glass.
Caution! Do not touch UVC tubes directly with your hands; put on cotton gloves!
Do not dispose of old, broken UVC tubes in the household waste. Consult your local disposal company.
Do not use any sharp-edged tools. If the quartz glass piston or O-rings are faulty, they must always be
replaced.
Functional check of the UVC clarifier
You can check the function of the UVC tube by the bluish shimmer on the transparent intermediate ring of
the UVC clarifier (can be seen more easily with the filter cap removed). This check works best in low light.
If the UVC tube does not light up, the UVC clarifier may not have been assembled correctly. Check this using
the installation instructions above.
The UVC tube only lights up when the clarifier is completely assembled.
Winter - maintenance
Protect your replaceable pond filter from freezing!
If there is danger of freezing, take the pump out of your small pond.
Completely clean the pump as specified in the instructions.
Store the pump over winter in a frost-free location.
7. Warranty
The present device was manufactured and inspected according to the latest methods. The seller warrants for
faultless material and workmanship in accordance with the legal regulations of the country in which the
device was purchased. The warranty period begins with the day of the purchase and is subject to the
provisions below:
Within the period of warranty, all defects which are to be attributable to defective materials or manufacturing
will be eliminated free of charge. Any complaints are to be reported immediately upon their detection.
The warranty claim becomes void in the case of interventions undertaken by the purchaser or by third
parties. Damage resulting from improper handling or operation, incorrect setting-up or storage, inappropriate
connection or installation or Acts of God or other external influences are excluded from warranty.
Parts subject to wear, such as the UV–C tube, rotor and bearings are excepted from the guarantee. All parts
were manufactured using maximum care and high-quality materials and are designed for a long lifecycle. It
should be understood, however, that the wear and tear depends on the kind of use, the intensity of use and
the internals of maintenance. Complying with the installation and maintenance information contained in the
present operating instructions will therefore considerably contribute to a long lifecycle of these wearing parts.
In case of complaints, we reserve the option of repairing or replacing the defective parts or replace the entire
device. Replaced parts will pass into our property.
Claims for liquidated damages are excluded unless they are caused by willful acts or negligence on the side
of the manufacturer.
The warranty does not provide for any claims beyond those referred to above. The warranty claim has to be
evidenced by the purchaser in the form of the submission of the sales receipt. The present warranty
commitment is valid in the country in which the device was purchased.
Please note:
1. Should your device fail to function properly, please verify first whether an operating error or another
cause is present which cannot be attributed to a defect of the device.
2. In case you have to take or send in your defective device for repair, please be sure to enclose the
following documents:
a. Sales receipt (sales slip).
b. A description of the occurring defect (a description as accurate as possible will expedite the
repair work).
3. In case you have to take or send in your defective device for repair, please remove any attached parts
which do not belong to the original condition of the device. If any attached parts of this kind should be
missing upon the return of the device, we shall not be liable for them.
12
5

Publicité

loading