Cosatto the ABCS Woosh 3 Mode D'emploi page 6

Sun visor 26-
27-
Hood 28-
29-
30-
31-
Seat cover 32-
33-
Pushchair 34-
Bumper bar 35-
36-
37-
Bumper bar cap 38-
39-
Bell 40-
Drink holder 41-
42-
Pushchair
4
Opening:
Closing:
Using the hood pocket:
Using the viewing window flap:
Fitting the raincover:
Removing is a reversal of this procedure.
Removing:
Refitting is a reversal of this procedure.
Removing:
Remove the harness (refer to step 16) & hood (refer to step 31) respectively.
Release the fabric fastener on the underside of the calf support (a).
Release the strap under the seat (b).
Unfasten the fastening tabs on each side of the seat cover (c).
Push down the backrest strap end to expose the opening of the «C» ring (a) and
slide the strap out of the ring (b).
Unfasten the fastening tabs on each side of the backrest (c).
Remove the seat cover off the seat (d).
Refitting is a reversal of this procedure.
Closing:
Always remove the raincover and store it under the seat.
Close the hood fully (refer to step 24) (a).
Slide the primary lock lever (b) and rotate the secondary lock handle forward FULLY
(c) to unlock the chassis.
Push the handle downwards (d) until the chassis is locked in place (e).
Fitting:
Opening:
Removing:
Fitting:
Removing:
Operating:
Fitting:
Removal is a reversal of this procedure.
Using the telescopic handle:
Retracting is the reversal of this procedure.
Note: the telescopic handle must be fully retracted when not in use.