Hilti NURON NPR 32 P-22 Mode D'emploi Original page 12

3 Description
3.1 Product overview
3.2 Intended use
The product described is a cordless, electro-hydraulic pressing tool.
It is designed for pressing fittings used to connect composite, steel and copper (Cu) pipes.
• For this product, use only Hilti Nuron lithium-ion batteries of the B 22 series. For optimum performance,
Hilti recommends the batteries stated in the table at the end of these operating instructions for this
product.
• For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
operating instructions.
3.3 Possible misuse
• Do not use this hand-held pressing tool clamped in a fixed position or as a stationary device.
• Do not use the electro-hydraulic pressing tool in heavy rain or under water.
3.4 Items supplied
Pressing tool, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
3.5 Status indicators of the Li­ion battery
Hilti Nuron Li-ion batteries can indicate state of charge, fault messages and the battery's state of health.
3.5.1 Indicators for state of charge and fault messages
WARNING
Risk of injury by a falling battery!
▶ If the release button is pressed with a battery inserted in the product, subsequently check that the battery
is correctly re-engaged and secure.
Short-press the release button of the battery to get whichever of the following status indications is applicable
at the time.
6 English
1
Pressing ring
@
Mounting groove
;
Gripper hook
=
Adapter jaw
%
Adapter jaw leg
&
Pressing jaw/adapter jaw mounting
(
Tool head
)
Attachment eye
+
Piston return switch
§
Control switch
/
Servicing and fault indicator
:
Battery
∙
Battery release button
$
Battery status indicator
£
Work-area light
|
Locking pin
¡
Pressing jaw leg
Q
Pressing die
W
2321658
*2321658*