Bimar MP1000M Notice D'instructions page 40

The scooter has the following adjustment and control elements:
Button:
-
 press for about one second to turn the device on (display on). When the scooter
is on, press the button:
twice to select the speeds. Press
-
symbol
corresponding to the selected speed
speed.
Press once to turn on the front and rear lights, the corresponding light "
-
lights up; to turn off the light, press the button once again.
 to turn off the device (display off) press the button for about three seconds, you
will hear a "beep".
 Battery status indicator: maximum power
Do not use the scooter when the battery percentage is low "
Rear brake and engine: to activate these, press the lever properly, without applying
-
too much force.
Accelerator: to activate, press the lever down gently; to disengage, release the lever.
-
Bag holder hook, battery charger
-
Autonomy: the scooter can cover a distance of about 15-20 km with a fully charged
battery in ideal conditions. Below are some of the main factors that may affect the
autonomy of the scooter.
Terrain:
A smooth, flat surface increases the distance that can be covered, while
riding uphill on uneven or rugged terrain significantly reduces the distance.
Weight:
The weight of the rider can influence the distance travelled; a lighter rider will
have a longer range than a heavier person.
Ambient temperature
temperatures, which will increase the distance, battery life and overall performance of
your scooter.
Maintenance
: Judicious battery charging and maintenance will increase the distance
that can be covered. Overcharging the battery may reduce battery life.
Speed and riding style: Maintaining a moderate speed increases the distance that can
be covered. The overall distance is reduced if you travel at high speed for long
periods, with frequent starts, stops, breaks, or if you leave your scooter on, or if you
frequently accelerate and decelerate.
Use
Before using the scooter for the first time: check the brakes, tyres (wheels should have
pressure of about 2.5 bar (atmospheres)).
Both lights (front and rear) should be switched on during use.
Use your scooter at the lowest speed to learn how to ride safely, before travelling at
top speed.
To operate the device, press the button for approximately one second (display on).
Place one foot on the deck and push off with the other to bring the scooter to a speed
of about 6km/h, then press the accelerator lever down and place the second foot on
the deck to start riding. You can use the button to select the desired speed.
"= green colour = average speed.
".
: Please rider and store your scooter at the recommended
the button twice to change the speed
lights up
"= red colour = maximum speed.
: no symbol = minimum
" " and minimum power" "
".
the
,
"