Orbegozo AHL 2000 Manuel D'instructions page 11

AHL 2000
• Do not use the product if it is wet or in rooms with a
high level of humidity, such as bathrooms etc.
• To put it into operation, put the regulator in position for
maximum 20 minutes to obtain a rapid heating and then
switch to the low position. The position of maximum
heat is used only for the rapid warming and never more
than 20 minutes.
• Do not fold or bend the electric cord and do not use
your blanket when it is folded up, rolled up or bent on
itself.
• Wear it over a garment.
• Do not cut or pierce the heating blanket. Do not make
holes using pins or dull instruments. Do not disassemble
it
OPERATION
The heating pad can smell plastic during the first use but it will disappear after a short period of time.
ON/OFF
To use the device, first connect the controller to the pad and then plug the controller into a power outlet.
Place the heating pad in the waist fitting it with elastic band.
Switch on:
Select the highest temperature level (level 3) a short period of time before use, so the pad will warm up
faster. Select the level of temperature control 1 to 3. If you use the pad for a few hours select an average
temperature (level 2).
Shutdown:
Select the level 0 on the remote to turn off the heating pad and unplug from the wall outlet.
TEMPERATURE LEVELS
Level 0: off.
Level 1: minimum heat. Recommended in continuous use.
11