Publicité
Les langues disponibles
Les langues disponibles
3.
Pull the filters out of the dirt receptacle (C). Empty the canister.
4.
Remove the HEPA filter (A) from the coarse debris filter (B). Pay attention to the lock
symbol.
A. HEPA filter: this round dust filter captures the small dust particles.
B. Coarse debris filter: this ensures that the large dust particles remain in the dirt
receptacle.
C. Dirt receptacle: this is where all large dirt particles are collected.
5.
You can now clean all the parts separately. We recommend you do this with compressed
air. If you do not have compressed air, you can wash out the parts. Make sure they are
completely dry before using them again.
6.
Replace the HEPA filter in the coarse debris filter. Pay attention to the lock symbol.
7.
Put the filters back in the dirt receptacle.
8.
Click the dust container back onto the motor part.
2
We advise replacing the filters regularly to ensure an optimal operation of the machine. Dirty filters will
reduce the suction power drastically. For the best results, clean the dust reservoir and the filters after
each use. This is better for the suction power and the life span of the machine.
CLEANING THE ROTATING BRUSH
Hair and threads can get stuck in the brush of the floor nozzle over time. These will prevent the brush
from efficiently picking up the dirt and bringing it to the suction opening. Clean the rotating brush
according to the following steps:
1
1.
Remove the floor nozzle from the upright vacuum cleaner.
2.
Unscrew the cap at the right side of the floor brush (position "UNLOCK") with a coin or other
appropriate tool. Once you have opened the lock, you can release the cover by pulling on it.
3.
Remove the rotating floor brush from the floor nozzle.
4.
Remove hairs and other dirt that have wrapped around the floor brush. If you do not clean the floor
brush regularly, it will become damaged and your machine will become unusable.
5.
The rotating floor brush may be rinsed off under running water. Make sure that it is completely dry
before using it.
6.
Place the floor brush back into the floor nozzle when it is clean.
7.
Put the cap back onto the floor nozzle and tighten it (position "LOCK").
8.
Push the nozzle back onto the stick. The machine is now again ready for use.
30
DO1100SV
3
2
4
3
A
B
C
Publicité
