Publicité
Les langues disponibles
Les langues disponibles
4. Using an incomplete or damaged product represents
a hazard to people and property.
5. Ensure that you have all the accessories and tools
needed for assembly and operation. This also
includes suitable personal protective equipment.
ASSEMBLY
1. Mount the auxiliary handle (A) onto the drill by first
sliding the brass ring over the flat shoulder of the tool
body and then screwing the handle onto the threaded
part of the brass ring. Make sure that the handle
assembly is tight.(See Figure 1)
NOTE: The handle can be located
atdifferent position around the drill. First
loosen the handle grip and adjust the
position. Then retighten.
2. Remove the air inlet protective cap from the air inlet
(D). (See Figure 2)
3. Mount a male plug by hand into the air inlet (D).
(See Figure 3)
NOTE: Use thread sealant tape (not
included) on the male plug and tighten it
with a wrench for airtight connection. Do not
overtighten.
4. Place 2 - 3 drops of air tool oil (not included) into
the male plug before each use. (See Figure 4)
5. Open the claw (G) by turning the chuck (F)
counterclockwise with hand. (See Figure 5)
6. Insert a drill bit (not provided) into the
claw (G) as far as it will go and turn the
chuck (F) clockwise by hand. Make sure
the drill bit is installed securely and tightly.
(See Figure 6)
WARNING! Only use drill bits
that have a RPM rating equal
to or greater than the tool itself.
1/2" AIR DRILL
6
Publicité
