EAS ELECTRIC EMTD9PZ Guide D'utilisation page 56

MAINTENANCE
Problem
•Display is not on
• " "is lighting
•" "is light ing
•Dryer does not start
•Degree of dryness was
reached or drying time too
long
•There are humming noises
•The dryer switches off at
the end of the programme
Warning!
！
If you cannot deal with the problems by yourself and need help:
• Press the 【On/Off】button.
• Pull out the mains plug and call the service.
Solution
• Check if the power supply works.
• Check if the mains plug is inserted.
• Check the selected programme .
• Press the 【On/Off】button.
• Check the water container. If it's full, please pour
out the condensate water and restart the dryer.
• If the container is not full, please restart the
dryer directly.
• If the " " icon is still lighting after you have
finished the first two steps, please call the service.
• Clean the lint filter.
• Connect the tumble dryer to the mains.
• Turn on the tumble dryer.
• Check the the door is closed.
• Check the programme is set.
• Press the【Start/Pause】button.
• Clean lint filter and
• Empty the water container.
not
• Check the drain hose.
• Check installation place is appropriate.
• Keep the air inlet clean.
• Use higher drying intensity level programme or
time programme.
• The compressor is operating. These noises are
quite normal and do not indicate a fault.
• The dryer switches off automatically for energy
saving. This is not an error but a normal function.
26
heat exchanger .
V.2