EAS ELECTRIC EMTD9PZ Guide D'utilisation page 52

MAINTENANCE
Cleaning and Care
Empty the water container
1. Pull out and hold the water container
with two hands.
2. Tilt the water container, pour out the
condensate water into the basin.
3. Install the water container.
Warning!
！
• Empty the water container after each use. Once the water container is filled
completely, the programme will be paused and the " " icon will light. After
the container is emptied, the dryer can be restarted by pressing
【Start/Pause】button.
• Do not drink the condensate water.
• Do not use the dryer without the water container.
Clean the filters
This dryer has a primary door lint filter and a base filter in front of the heat exchanger
for additional protection. Make sure you clean the door filter after each cycle.
The base filter need to be cleaned after each fifth drying programme.
Clean the door
1. Open the door.
2. Take out the door
3. Open the filter and remove the fluff on
the filter, You can clean it in
4. Dry the door filter thoroughly before
installing it back.
Note!
• Take notice of the correct orientation
before to insert the door filter.
filter
filter.
running water.
22
Door Filter
V.2