Publicité
Les langues disponibles
Les langues disponibles
a.
Running belt loose adjustment
If the running belt is too loose, step off the treadmill, insert a hex wrench into the adjustment hole
of the left guard and rotate clockwise 1/4 turn, and then rotate 1/4 lap clockwise on the right foot.
Pay particular attention when tightening the belt and ensure both sides are adjusted
synchronously, so that the running belt can be tightened and will not deviate from the centre point.
If the running belt is too tight, adjust the left and right synchronisation counter clockwise.
Note: The running belt cannot be adjusted too tightly. This will pull the running belt, increase the
pressure of the front/rear drum, and damage the drum bearings, resulting is damage to the
treadmill. Only adjust the running belt so that it does not slip during operation.
b.
Running belt alignment
When you use a treadmill, the pressure on the running belt is unbalanced because the force of
both feet is not the same when running, causing the running belt to deviate from the centre. This
deviation is normal, and when no one is running on a running belt, it automatically returns to the
centre. If your belt does not do this, you will need to run the belt back to centre.
Run the treadmill without stepping onto it, and increase the speed to 6th gear, observe the distance from the
left and right-side bars:
● If left, use a hex wrench to rotate the left screw clockwise 1/4 turn;
● If right, use a hex wrench to rotate the right screw clockwise 1/4 turn;
● If the running belt is still not in the middle, repeat the above action until adjusted to the middle.
After adjusting the belt to the middle, adjust the speed to 6th gear, and observe the deviation of the running
belt and the smoothness of the run, if there is a deviation, repeat the adjustment step.
Warning! Do not over tighten the drum! This will result in permanent damage to the bearings!
7.
LUBRICANTS
Treadmills are oiled when they are shipped, but the lubricity of the treadmills is often checked to help keep the
treadmills at peak use. The treadmill must be lubricated after one year of use or 100 hours of operation.
After 30 hours or 30 days of use, with the treadmill stationary, pull the starting belt from the side to reach as
far as possible to touch the table surface, if you can feel the lubricant, do not need to add lubricant. (Use non-
petroleum lubricants).
~ 9 ~
Publicité
