ENGLISH
Check the door gasket regularly to make sure
there are no debris.
Please turn off the power before cleaning,
remove all food, shelves, drawers, etc.
Clean the door gasket with mild soap and
water. Use a soft cloth or sponge to clean the
inside of the refrigerator, with two tablespoons
of baking soda and a quart of warm water.
en rinse with water and wipe clean, and open
the door and dry it naturally before the power is
turned on.
For areas that are difficult to clean in the
refrigerator (such as narrow sandwiches, gaps or
corners), it is recommended to wipe them
regularly with a soft rag, soft brush, etc. and
when necessary, combined with some auxiliary
tools (such as thin sticks) to ensure no
contaminant accumulation in these areas.
Do not use soap, detergent, scrub powder,
spray cleaner, etc., as these may cause odors in
the interior of the refrigerator.
Clean the bottle frame, shelves and drawers
with a mild detergent and dry with a soft cloth.
Wipe the outer surface of the refrigerator with
a soft cloth dampened with soapy water,
detergent, etc., and then wipe dry.
GB-24
Do not use hard brushes, clean steel balls, wire
brushes, abrasives, such as toothpastes, organic
solvents (such as alcohol, acetone, banana oil,
etc.), boiling water, acid or alkaline items clean
refrigerator considering that this may damage
the fridge surface and interior.
Boiling water and benzene may deform or
damage plastic parts.
Do not rinse with water so as not to affect the
electrical insulation properties.
It is advisable to clean the appliance regularly
and to remove any food deposits or splashes; in
particular, clean the door seals, recesses and
adjacent parts.
Don't overlook parts of the appliance such as
the humidity controller, light casing, racks, egg
and butter compartments, ice cube tray, and all
of the drainage areas, etc.
If the appliance is not kept clean and in good
condition, its surface could deteriorate and
inexorably affect the length of its service life,
and could lead to a dangerous situation.
e appliance must not be steam cleaned.
Use only a non-abrasive sponge, rinse with
clean water then dry thoroughly before putting
the parts back in place.
ENGLISH
GB-25