TecMate TM367 Mode D'emploi page 9

NOTES ON TEST RESULTS: The voltage of a cooled battery is directly proportional to its State Of Charge
percentage (SOC%). Immediately following charging a battery may briefly hold a higher voltage, as charging
raises the temperature of chemical elements within the battery. A battery recovered from a deep discharged
state may need longer to cool and voltage to settle and reflect its true state of charge (SOC%).
1. For any test result other than green #6 (or green #6 and yellow #7 together if the battery is a STD type
with filler caps), disconnect the battery from the electrical system it supports, and reconnect the OptiMate. If
a better test result is now obtained, this suggests that the power losses are partly due to an electrical
problem in the electrical system and not in the battery itself.
2. If the red LED #8 alone, or the yellow #7 & red LED #8 indicate together, or yellow #7 LED alone for a
sealed battery, a significant problem exists. The battery is unable to retain sufficient charge or is losing
charge very fast due to connected circuitry. A sudden load being switched on while the charger is connected
can also cause the battery voltage to dip significantly.
3. GOOD TEST RESULT, but the battery cannot deliver sufficient power: battery is worn, its capacity has
reduced. Degraded inter-cell connections or poor external connection at battery posts may cause severe
voltage drop when high current is demanded from the battery. Check external battery connections or have
battery professionally assessed (load tested).
ECO POWER SAVING MODE WHEN THE CHARGER IS CONNECTED TO AC SUPPLY:
The power converter switches to ECO mode when the charger is not connected to a battery resulting in a
very low power draw of less than 0.5W, equivalent to power consumption of 0.012 kWh per day. When a
battery is connected to the charger power consumption depends on the current demand of the battery and
its connected vehicle / electronic circuitry. After the battery has been charged and the charger is in long term
maintenance charge mode (to keep the battery at 100% charge) the total power consumption is estimated to
be 0.024kWh or less per day.
LIMITED WARRANTY
TecMate (International) SA, B-3300 Tienen, Belgium, offers this limited warranty to the original purchaser at retail of this
product. This limited warranty is not transferable. TecMate (International) warrants this battery charger for three years from
date of purchase at retail against defective material or workmanship. If such should occur the unit will be repaired or replaced
at the option of the manufacturer. It is the obligation of the purchaser to forward the unit together with proof of purchase (see
NOTE), transportation or mailing costs prepaid, to the manufacturer or its authorized representative. This limited warranty is
void if the product is misused, subjected to careless handling, or repaired by anyone other than the factory or its authorized
representative. The manufacturer makes no warranty other than this limited warranty and expressly excludes any implied
warranty including any warranty for consequential damages.
THIS IS THE ONLY EXPRESS LIMITED WARRANTY AND THE MANUFACTURER NEITHER ASSUMES NOR AUTHORIZES ANYONE TO
ASSUME OR MAKE ANY OTHER OBLIGATION TOWARDS THE PRODUCT OTHER THAN THIS EXPRESS LIMITED WARRANTY. YOUR
STATUTORY RIGHTS ARE NOT AFFECTED.
NOTE: Details at www.tecmate.com/warranty.
WARRANTY in Canada, USA, Central America and South America:
TecMate North America, Oakville, ON, Canada, as a wholy owned subsidiary of TecMate International, assumes the
responsibility for product warranty in these regions.
More information on TecMate products can be found at www.tecmate.com.
9