Atag WS90211EM Notice D'utilisation page 30

USE
I
EN 6
Switching on the timer
• Switch on the extractor cap with button 'A'.
• Set the extraction strength with buttons 'B' and 'C'.
• Press the Timer button 'F'.
The extractor cap switches off automatically after 30 minutes.
Switch off the Timer function by pressing button 'F' again, or by
switching off the extractor cap with button 'A'. The display shows
the selected speed and the remaining time.
Activating the alarm signal
• In recirculation version hoods, the filter saturation alarm must be
activated on installation or at a later date.
• Turn the lights and the motor off.
I
• Press 'D' and hold for approximately 5 Seconds:
- The display shows 'FC' and the indication on the bottom right flashes
twice. The filter saturation alarm is ACTIVATED
- The display shows 'FC' and the indication on the bottom right flashes
once. The filter saturation alarm is DEACTIVATED
Grease filter indicator
After 100 hours of use the "F6" indicator is shown in the display.
• Clean the grease filters.
Odor/fine dust filter indicator
After 200 hours of use the "FC" indicator is shown in the display.
Replace your combination of odor/fine dust filter at least every year, or
sooner if the efficiency is greatly reduced.
Reset the filter indicator alarm
• Turn the Lights and the motor off.
• Press button 'E' for 3 seconds.