Kicker ZXM.5 Serie Manuel D'utilisation page 2

Authorized KICKER Dealer:
Purchase Date:
Model Number:
Serial Number:
PERFORMANCE
RMS Power:
AMP1 & AMP2 channels driven
@ 14.4V, 4Ω stereo,  1% THD+N
@ 14.4V, 2Ω stereo,  1% THD+N
@ 14.4V, 4Ω mono,  1% THD+N
RMS Power:
SUBWOOFER channel driven
@ 14.4V, 4Ω mono,  1% THD+N
@ 14.4V, 2Ω mono,  1% THD+N
Length
Specifi cations:
Height
Width
Frequency Response ± 1dB
Signal-to-noise Ratio
Input Sensitivity
Selectable Electronic Crossover
Bass Boost
Subsonic Filter
Pro Tip: To get the best performance from your new KICKER Amplifi er, use genuine KICKER accessories and
wiring.
INSTALLATION
Mounting: Choose a structurally sound location to mount your KICKER amplifi er. Make sure there are no items
behind the area where the screws will be driven. Choose a location that allows at least 4" (10cm) of open
ventilation for the amplifi er. If possible, mount the amplifi er in the climate-controlled passenger compartment. Drill
four holes using a 7/64" (3mm) bit and use the supplied #8 screws to mount the amplifi er.
Wiring: Disconnect the vehicle's battery to avoid an electrical short. Then, connect the ground wire to the
amplifi er.
2
2010 ZXM 700.5 RevD.indd 2 2010 ZXM 700.5 RevD.indd 2
ZXM.5-SERIES AMPLIFIERS Owner's Manual
ZXM700.5
70W x 4
85W x 4
165W x 2
210W x 1
420W x 1
20" (507mm)
2-1/8" (54mm)
9-5/8" (244mm)
25Hz–20kHz
>95dB, A-weighted, re: rated power
Low Level: 125mV–5V
High Level: 250mV–10V
Variable HI or OFF (bypass) | 50–200Hz, 12dB/octave
Variable low-pass | 50–200Hz, 24dB/octave (SUB)
Variable 0–18dB @ 40Hz
24dB/octave, fi xed at 25Hz
ZXM AMPLIFIERS
10/29/2009 1:25:04 PM 10/29/2009 1:25:04 PM