Ryobi RY18SPA Manuel D'utilisation page 5

TRANSPORTING LITHIUM BATTERIES
Transport the battery in accordance with local
and national provisions and regulations.
Follow all special requirements on packaging
and labelling when transporting batteries
by a third party. Ensure that no batteries
can come in contact with other batteries or
conductive materials while in transport by
protecting exposed connectors with insulating,
nonconductive caps or tape. Do not transport
batteries that are cracked or leaking. Check
with the forwarding company for further advice.
MAINTENANCE
■ Use only original
replacement parts,
attachments. Failure to do so can cause
possible injury, can contribute to poor
performance, and may void your warranty.
■ Servicing requires
knowledge and should be performed only
by a qualified service technician. Have the
product serviced by an authorised service
centre only.
■ You may make adjustments and repairs
described in this manual. For other repairs,
contact an authorised service centre.
■ Periodically inspect the pump, hoses, and
water inlet. Ensure that the hoses and water
inlet are free from mud, sand, and debris.
■ After each use, clean the product with a
soft, dry cloth. Keep the product dry, clean,
and free from oil and grease when not in
use. Any part that is damaged should
be properly repaired or replaced by an
authorised service centre.
■ Clean the filter only when there is noticeable
decline of functionality.
■ Bring the product to an authorised service
centre to replace damaged or unreadable
labels.
KNOW YOUR PRODUCT
See page 155.
1. Operator's manual
2. Cable
3. Submersible pump
4. Filter switch
5. Locking pin
6. Discharge elbow
7. Air lock valve
8. Screw
manufacturer's
accessories, and
extreme care and
9. Handle
10. Control panel
11. Power connector
12. Battery box
13. Battery cover
14. On/off button
15. Low battery LED indicator
16. Timer button
17. Timer LED indicator
18. Water sensor LED indicator
19. Clip hook
20. Wall mount hook
21. Latch
22. Flexible hose
23. Hose clamp
24. Battery pack
25. Charger
26. Mounting screw
FILTER SWITCH
Make sure to set the fi lter switch to the correct
setting depending on the type of water where
the product is used. If the product is used in
dirty water, slide the fi lter switch to the left, and
if the product is used in clean water, slide the
fi lter switch to the right.
AIR LOCK VALVE
The air lock valve automatically relieves air in
the submersible pump while it is submerged
in water. Always keep the air lock valve clean
and free of any blockage. Make sure that the
air lock valve is tightened and secured and the
ball inside the valve can move freely.
SYMBOLS ON THE PRODUCT
Read and understand all
instructions before operating the
product. Follow all warnings and
safety instructions.
Ukraine Conformity Mark
British Conformity Mark
EurAsian Conformity Mark
European Conformity Mark
5
Original Instructions
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR