Cramer 82T10 Manuel D'utilisation page 8

WARNING!
Do not attempt to modify this product or create accessories
not recommended for use with this string trimmer. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING!
To prevent accidental starting that could cause serious
personal injury,always remove the battery pack from the
product when assembling parts.
Attach the guard
(see Figure 2)
WARNING!
Avoid contact with the blade. Failure to avoid contact can
result in serious personal injury.
1 Invert the string trimmer to access the trimmer head.
2 Put the lower shaft into the groove of the guard.
3 Insert the bracket into the slot. Align the screw holes on the bracket with the
screw holes on the guard.
4 Install and tighten the screws.
Attaching the auxiliary handle
Press the auxiliary handle onto the shaft so that the handle is angled toward
1
the rear handle that allows for comfortable operation.
2 Insert the clamp into the slot on the handle.
(see Figure 3)
3 Align the hole on the handle with the hole on the clamp.
4 Insert the handle knob through the auxiliary handle.
5 Tighten until there is no movement in the handle.
Installing the battery pack(see Figure 4)
• Put the battery pack in the trimmer. Align the raised ribs on battery pack
with the grooves in the trimmer's battery port. Make sure the battery pack
is fully seated and secured in the trimmer before beginning operation.
Removing the baterry pack (see Figure 4)
1 Push and hold the battery release button on the side of the rear housing.
2 Take out the battery pack and release the button.
Operation
WARNING!
Do not allow familiarity with products to make you careless.
Remember that a careless fraction of a second is sufficient to
inflict serious injury.
WARNING!
Always wear eye protection. Failure to do so could result in
objects being thrown into your eyes resulting in possible serious
injury.
EN GB
7
cramer.eu