Publicité
Les langues disponibles
Les langues disponibles
Cutting line replacement (see Figure 10)
EN
•
Remove the battery pack.
•
Remove the spool from the cutting head.
NOTE: Remove any old cutting line remaining on the spool.
•
Cut a piece of cutting line approximately 3m long.
•
Bend the line at the midpoint and hook the loop into the slot in the center
rim of the spool. Ensure the line snaps into position in the slot.
•
Wind the line in the direction of the arrow shown on the bottom of the
spool. Once completed, put the line in the slots so it does not unwind.
•
Do not wind the line beyond the edge of the spool.
Storing the trimmer
•
Remove the battery pack from the trimmer before storing.
•
Clean all foreign material from the trimmer.
•
Store it in a place that is inaccessible to children.
•
Keep away from corrosive agents such as garden chemicals and de-icing
salts.
•
Store and charge your batteries in a cool area. Temperatures above or below
normal room temperature will shorten battery pack life.
•
Never store batteries in a discharged condition. Wait for battery pack to cool
and fully charge immediately.
•
Store the battery pack where the temperature is below 23˚C and away from
moisture.
•
All batteries gradually lose their charge. The higher the temperature, the
quicker they lose their charge. If you store your unit for long periods of time
without using it, recharge the batteries every month or two. This practice
will prolong battery pack life.
•
Secure the trimmer during transport to prevent damage or injury. Clean and
maintenance before storage, use of guards on cutting attachments with
metal blades. Use of cover for metal blades during transport and storage.
Environmental protection
•
Environmental protection should be a priority of considerable importance
when using the machine, for the benefit of both social coexistence and
the environment in which we live. Try not to cause any disturbance to the
10
cramer.eu
surrounding area.
•
Carefully comply with local regulations for the disposal of packaging,
deteriorated parts or any elements with a strong environmental impact;
this waste must not be disposed of as normal waste, it must be separated
and taken to specified waste disposal centres where the material will be
recycled.
•
Carefully comply with local regulations for the disposal of waste materials
after mowing.
•
At the time of decommissioning, do not pollute the environment with the
machine, but hand it over to a disposal centre, in accordance with the local
laws in force.
Publicité
