Publicité
Les langues disponibles
Les langues disponibles
6-B
WPA/WPA2
1
Enter the network key in Passphrase (L).
•
Enter upper and lower case letters of the alphabet correctly when the network key is
between 8 and 63 characters. Letters are case sensitive.
Letters are not case sensitive if the network key is 64 characters.
2
Select Dynamic Encryption Type (M), then click OK (N).
•
When WEP (Transitional Security Network) is selected in AirPort Utility, select
AES(Secure Encryption).
Go to
.
7
The Manual Setup screen returns. Click Connect.
•
After that, follow the on-screen instructions to proceed with settings.
0
Disable
L
M
N
Restoring the Machine's Default LAN Settings to Perform Setup Again
Action
Follow the procedure below to restore LAN settings of the machine to the default state.
1
Use the Menu button to select Device settings.
2
Use the [ or ] button to select LAN settings, then
press the OK button.
3
Select Reset LAN settings, then press the OK button.
4
Select Yes, then press the OK button.
5
Make sure that the screen shown to the right appears.
•
After a while, the Device settings screen returns. Press the
COPY button.
The LAN setting of the machine is now restored to the default state.
•
Perform setup by following the procedures in "10 Set Up a Wireless Connection" on page 38 and
onward in the printed manual: Getting Started.
<Default State>
Wireless LAN
Inactive
SSID
BJNPSETUP
Data encryption
Inactive
TCP/IP setting
Obtain an IP address automatically
Publicité
