Philips Lumea SC1995 Mode D'emploi page 17

Handling the device
All manuals and user guides at all-guides.com
Note: Your skin may react differently on different days/occasions for a
number of reasons.
1 Before use, clean the attachment and the light exit window.
2 Put the small plug in the device and put the adapter in the wall socket.
3 Switch on the device and select the right light intensity for your skin tone.
4 Place the device at a 90° angle on the skin so that the attachment and
the integrated safety system are in contact with your skin.
The integrated safety system prevents unintentional flashing without skin
contact..
5 Press the device firmly onto your skin to ensure proper skin contact. The
'ready to flash light' on the back of the device lights up green to indicate
that you can proceed with the treatment.
6 Press the flash button to release a flash. You should feel a warm
sensation because of the flash.
Note:The light produced by the device is harmless to your eyes. It is not
necessary to wear goggles during use. Use the device in a well-lit
room so that the light is less glaring to your eyes.
7 Place the device on the next area to be treated. After each flash, it takes
up to 3.5 seconds until the device is ready to flash again. You can release
a flash when the 'ready to flash' light lights up again.
17
English