Samsung WA40B3005A Serie Manuel D'utilisation page 53

Code
Mid LED A fault is detected in the water level sensor.
Flashes If the information code remains, contact a customer service center.
Your washer is not draining. It can also mean that the unit senses a small
clog while draining.
•
Low LED
1. Turn off the unit and turn it on again.
Flashes
2. Select only the Spin Only.
3. Press the START/PAUSE to drain the water. If it still does not drain,
Hot &
Unbalanced load prevented your Washer from spinning.
Warm LEDs
•
flash
Motor not running properly.
Hot & Cool
•
LEDs flash
•
Hot & Cool Mems sensor is not working properly.
LEDs flash •
Hot & Extra Door lock is not working properly.
High LEDs •
flash •
Door lock is not working properly.
Hot & High
•
LEDs flash
•
Hot & Mid Thermistor is not working properly.
LEDs flash •
The temperature of the supplied water is so high.
Hot & Low •
LEDs flash
•
For any codes not listed above, call 1–800–726–7864 (1–800–SAMSUNG).
WA40B3005AW_UM_DC68-00000A-00_EN.indd 53 WA40B3005AW_UM_DC68-00000A-00_EN.indd 53
Do the following:
contact a customer service center.
Redistribute the load, and then press the START/PAUSE button.
Restart the cycle by presssing the START/PAUSE button.
If the information code remains, contact a customer service center.
If the information code remains, contact a customer service center.
Close the lid tightly and restart the cycle.
If the information code remains, contact a customer service center.
Close the lid tightly and restart the cycle.
If the information code remains, contact a customer service center.
If the information code remains, contact a customer service center.
Ensure that the cold water tap and the hot water tap are connected
correctly.
If the information code remains, contact a customer service center.
Meaning
English 53
2022-08-25 2022-08-25 10:19:17 10:19:17