McCulloch 966805003 Manuel Du Propriétaire page 6

6. Install the front mount bracket to the deck with the
pin and hairpin cotter supplied with the kit.
Outer Pulley
Cover
INSTALLING DRIVE BELT
1. Place the belt over the pulley on the deck. Refer to
illustration for proper routing.
2. Move the tension release arm to the rear and
engage in the latch.
Tension
Release Arm
Rear of Deck Idler Pulleys
INSTALLING BELT COVERS
1. Place the deck belt shield on the deck over the
drive pulley and secure with hardware removed
from steel belt shield.
2. Place retainer on the outer pulley cover.
3. Align the tab end of the belt cover into the slot on
the deck belt shield and the other end over the end
of the outer pulley cover.
4. Secure with knob.
6
ASSEMBLY
Hairpin
Cotter
Pin
Outer Pulley
Twist in Belt
Belt Cover Tab
Deck Belt Shield
Outer Pulley Cover
CHUTE SUPPORT
1. Position upper chute support against bagger inlet,
flush at outer edges. See Illustration.
2. Using support as a template, drill two
bagger hood.
3. Secure upper chute support to hood with hex bolts,
washers and nyloc nuts.
Retainer
/ holes into
3
8
Upper Chute
Support
Flex Trim