Publicité
Les langues disponibles
Les langues disponibles
Fig. 1
Configurations for MaxiFit Flange Adaptors
Type 1 Straight Sleeve
Fig. 2
Fig. 5
Fig. 6
DN50 (2") to DN150 (6")
MaxiDaptor FA's have
Flange configurations are combined PN10 and PN16.
common bolt holes for all
To assemble against mating flange, locate the four
drillings.
common holes first, the remaining holes will then
align with their respective mating flange holes.
Fig. 7
Type 2 Expanded Sleeve
Fig. 3
DN175 (7")
DN200 (8")
Fig. 8
Type 3 Expanded Sleeve
Fig. 4
DN225 (9") to DN300 (12")
DN350 (13") & Above
Flange configurations for bolting to PN10, PN16 or
ANSI Class 150 flanges. Connect the MaxiDaptor
to the other flanges using the appropriate flange
bolt holes.
Every effort has been made to ensure that the
information contained in this publication is accurate
at the time of publishing. Crane Ltd assumes no
responsibility or liability for typographical errors
or omissions or for any misinterpretation of the
information within the publication and reserves the
right to change without notice.
REV01
Publicité
