monte carlo 5WS52 D-L Serie Instructions D'installation page 6

41
Clip
Place the motor housing on the polyfoam
as shown, then locate the mounting plate
to the housing by aligning the clips on the
housing with holes in the mounting plate
44
Place motor housing cover over the
mounting plate.
47
Position the pin through the two
holes in the downrod and align the
hanger ball so the pin is captured in
the groove in the top of the hanger
ball. Note: Pin must be installed
with downrod and hanger ball.
50 Safety cable installation
Safety Cable
Lag Screw
safety
cable
washer
lock
3" lag
washer
screw
Fan and light kit combinations over 35 lbs, in
both flush and downrod mode the safety cable
must be installed into the house structure
beams using the 3" lag screws,washers, and
lock washers. provided. Make sure that when
the safety cable is fully extended the leadwires
are longer than the cable and no stress is
placed on the leadwires.
All manuals and user guides at all-guides.com
42
Clip in
tion
Hold the motor housing and turn mount-
ing plate clockwise by screwdriver to hold
it with housing in position. Make sure that
the clips are engaged with the mounting
plate well.
45
Thread the leadwires through the
canopy and Place the canopy over
the downrod.
48
Pull the hanger ball up tight against
the pin and securely tighten the
setscrew in the hanger ball. A loose
setscrew could create fan
wobble.
51
Make sure the studs protruding from
the bottom of the mounting bracket
are installed with threads all the way
through the bracket.
43
posi-
Thread the lead wires through the
motor housing cover
46
Thread the leadwires through the
hanger ball and place onto the
downrod.
49
Hang assembled fan from the mounting bracket
installed to ceiling in previous step. Make sure the
fan is hanging straight. Rotate fan until the tab on
the Mounting bracket engages the slot on the
Downrod Ball. This must be done to prevent the fan
body from rotating when the blades are in motion.
52
House
Black
White
Ground
Connect black and blue wire from
fan to Black or (Hot) wire from
house. Connect White wire from Fan
to White (Neutral) wire from house.
Connect Green leads from mounting
bracket, and downrod to the Ground
lead from house. Refer to
Diagram above.
Fan
Blue
Black
White
Green