Publicité
Les langues disponibles
Les langues disponibles
29
Install switch cap onto fan using 3
screws removed from step 18 and
tighten securely.
32
Remove the hanger ball by loosening
the setscrew in the hanger ball until
the ball falls freely down the down-
rod. Remove the pin from the down-
rod, then remove the hanger ball.
Save the pin and hanger ball for later
use.
35
Thread the leadwires through the
downrod as shown.
38
Insert the pin through the yoke and
downrod until the point appears on
the other side.
All manuals and user guides at all-guides.com
30
Use metal outlet box suitable for fan support and
use only the screws provided with the outlet
box (must support 35 lbs). Before attaching fan
to outlet box, ensure the outlet box is securely fas-
tened by at least two points to a structural ceiling
member ( a loose box will cause the fan to wob-
ble). Remove the two outlet box screws provided
with the box, aligning the holes of the mounting
bracket with the holes of the outlet box. Re-install
the 2 outlet box screws securely.
33
Thread leadwires and safety cable
through the mounting plate.
36
Loosen the 2 set screws in yoke.
39
Install the keeper to pin.
31
Remove the cotter and keeper pins
and save for later use.
34
The studs on the mounting plate pro-
trude through the slots in the motor
bracket .Securely tighten the lock-
nuts onto the threaded studs.
37
Insert downrod into yoke. Align the
hole in the downrod with hole in the
yoke.
40
Tighten the 2 set screws on the
yoke once the downrod is in place.
Publicité
