Publicité
#PKGRIND13X
3-3/4"
Mounting & Turning the Blank
1"
Turn between centers as shown in Dia B below
1"
1' Jam Chuck
NOTE:
In order to determine the position of the grinder mechanism for gluing, a simple shop turned jig is helpful
Assembly
• Glue the grinding capsule into the hole in the wooden base 1/4" up from base
• Mix and spread epoxy glue over the ribs of the grinder assembly
• Insert the capsule through the bottom of the finished wood, to bottom on over the jig. See Diagram C.
Let dry
• Slide the grinder body over the shaft. The threaded shaft should protrude about a 1/4" through the top of
the grinder body. Position the body over the housing and mark the position of the mounting screws. Screw
into the wood.
• Insert the handle over the thread shaft
• Thread on the cap nut over the shaft
• Pour rock salt or pepper in through the sliding opening. Adjust the grind by turning the cap nut up or
down, for fine or course grind
Dia B
DIA B
3-3/4"
© 2020 PSI Woodworking Philadelphia PA 19115 - v06/20
1-1/2"
2-1/4"
60 Degree
Live Center
Mill Housing
Step: 1/4" H x 1-1/2" Diameter
Grinder Base
Wooden Jig
Step: 1-1/2" x 1/4"
Base: 2-1/2" round
PSI Woodworking Products
Using the Jig
Use Jig to position
capsule for proper
Assembly height
Inside shaft
Glued Capsule
Inside
Dia C
Publicité
