Chicago Pneumatic CP 0009 Instructions D'origine page 19

CP 0009, CP 0014
Before starting maintenance on the machine,
♦
clean it in order to avoid exposure to hazard
substances. See "Dust and fume hazards"
Use only authorised parts. Any damage or
♦
malfunction caused by the use of unauthorised
parts is not covered by warranty or product
liability.
When cleaning mechanical parts with solvent,
♦
comply with appropriate health and safety
regulations and ensure there is satisfactory
ventilation.
For major service to the machine, contact your
♦
nearest authorised workshop.
After each service, check that the machine's
♦
vibration level is normal. If not, contact your
nearest authorised workshop.
Every day
Before undertaking any maintenance or changing
the insertion tool on pneumatic machines, always
switch off the air supply and bleed the machine by
depressing the start and stop device then disconnect
the air hose from the machine.
♦ Clean and inspect the machine and its functions
each day before the work commences.
Conduct a general inspection for leaks and
♦
damage.
♦ Check that the air inlet nipple is tightened and
that the claw coupling is free from damage.
Check the function of the retainer. Make sure that
♦
it locks the insertion tool.
Change damaged parts immediately.
♦
Replace worn components in good time.
♦
Check the side bolts of the machine. Make sure
♦
that they are tightened.
If the machine is equipped with a muffler, check
♦
for damage.
Periodic maintenance
After each operating period of approximately 100
working hours or three times a year the machine
must be dismantled and all parts be cleaned and
checked. This work must be performed by authorized
staff, trained for this task.
9800 0547 90 | Original instructions
All manuals and user guides at all-guides.com
www.CrowderSupply.com • Toll Free: 888-883-5144
Safety and operating instructions
Tightening torques
CP 0009 Thru bolt nut
CP 0014 Thru bolt nut
Assembly
When assembly the machine, be aware of the
following:
12-14 ft.lbf (16-19
Nm)
20-23 ft.lbf (27-31
Nm)
19