Publicité
Les langues disponibles
Les langues disponibles
Care and maintenance - Oven
Oven light
The oven light is a standard 40-watt appliance bulb. It comes on when you open the
oven door.
Remove
Remove
Replace
Replace
Glass bulb cover
Glass bulb cover
Bulb
Bulb
CAUTION
To prevent electric shock, make sure the oven is turned off and cool before replacing
the oven light.
NOTE
• The oven light does not operate during the self-cleaning cycle.
• Remove the racks if they prevent you from accessing the oven light.
96
English
DOP30T940DS_DG68-01459A-00_EN+MES+CFR.indb 96-97
DOP30T940DS_DG68-01459A-00_EN+MES+CFR.indb 96-97
1. Turn off the oven.
2. Make sure the oven and oven light are
cool.
3. Open the door, and remove the glass
cover by turning it counterclockwise.
4. Remove the oven light from the socket
by turning it counterclockwise.
5. Insert a new 40-watt appliance bulb
into the socket, and then turn it
clockwise to tighten.
6. Reinsert the glass cover, and then turn
it clockwise to tighten.
Troubleshooting
If you run into unexpected trouble, look first for a solution in the tables below. If you
are still having trouble after trying the suggested solution, call 833-353-5483(USA),
844-509-4659(CANADA).
Gas safety
Problem
Possible cause
You smell gas.
The surface burner knob is
not in the Off position and
the burner is not lit.
There is a gas leak.
Surface burner
Problem
Possible causes
All burners do not
The power cord is not
light.
plugged into the electrical
outlet.
A fuse in your home may
be blown or the circuit
breaker may have tripped.
The gas supply is not
properly connected or
turned on.
Surface burners
The control knob is not set
do not light.
properly.
The burner caps are not in
place.
The burner base is
misaligned.
Action
Turn the burner knob to Off.
Clear the room, building, or area of
all occupants.
Immediately call your gas supplier
from a neighbor's phone. Do not call
from your phone. It is electrical and
could cause a spark that could ignite
the gas. Follow the gas supplier's
instructions.
If you cannot reach your gas
supplier, call the fire department.
Action
Make sure the electrical plug
is plugged into a live, properly
grounded outlet.
Replace the fuse or reset the circuit
breaker.
See the Installation Instructions that
came with your range.
Push in the control knob and turn it
to the Lite position.
Clean the electrodes.
Put the burner cap on the burner
head.
Align the burner base.
English
97
2023-01-17 오후 3:02:02
2023-01-17 오후 3:02:02
Publicité
